Serving Severn, Maryland
Water Damage Restoration in Severn, Maryland, from our Bowie base: published ranges up front, the loss scoped with moisture readings on site, and one written figure before work begins.

Severn counted 57,118 residents in the 2020 Census, the second largest community in our Anne Arundel County ring. Some homes lose a basement to a failed sump pump in one night of rain. Others lose a kitchen floor slowly, over months, to a dishwasher line that wept every cycle and rotted the subfloor in silence. We are Bowie Water Damage Restoration Company, based in Bowie, and Severn keeps us busy with both kinds.
Appliance leak water damage is where Severn work often starts. Dishwashers, ice maker lines, washing machines, and water heaters fail in unglamorous ways, and the water travels under flooring and behind cabinets where nobody looks. We trace the spread with moisture meters, extract what is pooled, and open only the material readings prove is wet. Water heater leak cleanup is its own regular call, since a failed tank can flood a utility room floor at once.
Emergency water extraction handles the louder events. When water stands in a room, extraction comes first, and structural drying and dehumidification follows with equipment placed from readings and drying performed to IICRC S500 standards. Basement water damage restoration covers below grade losses after heavy rain, including sump pump failure cleanup and flood damage cleanup.
Burst pipe water damage and frozen pipe water damage soak insulation, ceilings, and walls in minutes, and ceiling and wall water damage is often how the loss first shows. Hardwood floor water damage needs fast decisions, because boards dried early sometimes settle flat while boards left wet cup and stay cupped. Crawl space water damage, roof leak water damage, and sewage cleanup each carry their own handling, and sewage work is treated as a contaminated loss from the first minute. Where a leak ran long enough for mold to establish, mold remediation work proceeds under containment, following IICRC S520 and industry remediation standards. Reconstruction after water damage and insurance claim documentation, with photos and readings, complete the job.

A Severn homeowner noticed the kitchen floor felt spongy near the dishwasher, and readings confirmed moisture across a wide section of subfloor and into the base of two cabinet runs. We removed the dishwasher, took up the affected flooring, and cut out the saturated subfloor section. The cabinet bases dried in place after the toe kick sections came off, and drying equipment ran until the remaining framing reached dry readings.
No company in Severn publishes a local price list for water damage work. What exists are published cost guide figures, and we label them that way. Water mitigation commonly runs $1,300 to $5,800 in published cost guides. An average restoration project runs $3,000 to $3,867 in those same guides. Published data also puts a full insurance claim project including rebuild at an average around $13,954, and that is an insurance claim figure with rebuild included, not the price of drying alone.
Time is the most expensive ingredient in most Severn jobs. A leak caught the day it starts may need extraction and two days of drying in one room. The same leak found three months later can mean flooring, subfloor, and cabinet work, plus mold handling.
Our base is Bowie, and Severn is close enough that we work there constantly, with a measured approach. We would rather show you a dry reading on a wall you worried about than sell you demolition you did not need. Every Severn job leaves with a reading log and photo record, so you and your insurer see the same evidence we worked from.
Published cost guides put water mitigation commonly at $1,300 to $5,800, with an average restoration project at $3,000 to $3,867. A leak caught early usually sits in the lower part of that range, while one that rotted flooring or subfloor climbs. A full insurance claim project including rebuild averages around $13,954 in published data.
Yes. Severn addresses sit in Anne Arundel County, and repair or reconstruction after mitigation follows Anne Arundel County permitting in general terms. Mitigation itself, meaning extraction, drying, and cleanup, has no Maryland license category.
Watch for a soft or springy feel underfoot, boards that gap or cup, a musty smell that survives cleaning, or a water bill that climbs without explanation. Any of those earns a set of moisture readings.
No. Severn is inside our twenty community ring around our Bowie base. The quote form at the bottom of this page is the fastest way to reach us, and we follow up to schedule the visit.
Shut off the water at the main valve if you can do it safely, then move belongings off wet flooring. Avoid running lights or fans below a soaked ceiling. After that, send the quote form so extraction and drying can be scheduled quickly.
We set containment before disturbing affected material, remove what cannot be cleaned, and treat the surfaces that remain, following IICRC S520 and industry remediation standards. Maryland ended its mold remediation licensing act on July 1, 2019, so no Maryland license for the work exists to claim. We describe the standards we follow instead.
Tell us what got wet and when. We read every request that comes in and respond with the published range for that kind of loss and the next step, starting with a visit to take moisture readings and scope the drying plan.
Prefer to talk it through first? Send the form and we will call you back at the number you give us.